Big thanks to Cossiecrazy Mark

[MATCOS]

Mark very kindly did me some plating for my car as I found a few bits that I had missed, they weren't enough for me to get a batch together so I asked Mark if he would do them and this is the results.

before



After



Excellent service

Cheers once again Mark

[cosmagedon]

Awsome Does he do it himself?

[Mike Rainbird]

Where do those parts go?

[MATCOS]

Not sure who does them but the turnaround was so quick and its great quality too.
Mike they go in the engine, some distributor parts, firewall trim screw, crank sensor bracket etc.
Get plating

[The Radman]

us small t owners dont need these extra weighty items mat [apart from the firewall screw lol]

[Kelv]

us small t owners dont need these extra weighty items mat [apart from the firewall screw lol]

ive removed my firewall now aswell, so even more screw's to go into the spares pot.

they look good Mat, nicely done Mark

[redrsmk5]

if hes taken them where i think he has then its the same place that does all of my Chroming. A company called Niphos Near me in Crewe. as with most things the final results are only ever as good as the prep and they were prepped well Matt
They always do a fantastic job as i know mark uses them for his chrome too

[Mike Rainbird]

Not sure who does them but the turnaround was so quick and its great quality too.
Mike they go in the engine, some distributor parts, firewall trim screw, crank sensor bracket etc.
Get plating

Can you help me fill in my concourse log-book as well .

Actually, I'd rather stick nettles down YOUR Jap's eye (it's a fettish I have ).

[MATCOS]

Can you help me fill in my concourse log-book as well .

Actually, I'd rather stick nettles down YOUR Jap's eye (it's a fettish I have ).

I think I'll give that one a miss if it's all the same with you Mike


Mart, I surface derusted them first but didn't polish them as they would have come up even better, but the finish is still ace

[andyrs]

great finish matt, did you blast them first?

[SCS j1mbo]

i think they acid dip them first to remove dirt ect then plate

[Mark Barber]

i use a guy local mart for zinc work he is a dam site cheaper

[MATCOS]

great finish matt, did you blast them first?

No just soaked them in rust removing solution

[Craig H]

good finish on them Matt

[redrsmk5]

i use a guy local mart for zinc work he is a dam site cheaper

Really? have niphos gone expensive then Mark?