powerin dash clocks

[richyx]

can someone tell me how i can power my dash clock and banana pod clocks so i can see if the dials are ok as ive never tried them

and id like to check them so i can sell them

[kjc300]

Yes

There is a bulb holder on the back of the clocks that says 'non serviced part- do not remove'

you can put 12v across that as there is an exposed bit of metal on each side of it. It does matter which way round it goes though so if it doesn't work, try switching them round.


If you can't see what I'm on about then you can also just follow the circuit from the top bulbs and use the connector pins in the main plug socket off the top of my head 13 and 15 - but check.

The boost gauge will be tricky here's the wiring diagram - pin 1 and 2 which I think is the 2 pin plug. you will need to get 2 wires connected to the 2 bullet connector wires on the main clocks and put them across 1 and 2 on the clocks (doesn't matter which way round as it's AC)

WARNING be careful with the AC output wires!!!! 115v AC

[richyx]

well

just got them from hte attic

i carnt test the gauages as there is a pin snapped off so god knows what im going to do here as i was planning on selling them lol

i can see the bulb on the dash clocks your on about lookslike the track is burnt out and someone has put a bit of solder on it

so i just put 12v on each side of this bulb holder andthe dials should light up yeah?

the gauges i carnt do anything with as by the looks of it its the main live which has snapped red wire in plug and i dont have the pin

[cozzed]

Anythings fixable mate , don't dispare