Where can I buy a sheet of 3mm carbon

[jacko996]

As above, size 1250 x 750

Any ideas, looked at performance trim but his only go to 1.5mm

Ta Dave

[luca]

He will be able to make it to your requirements

Give Mike a call and see what he says


I was down there at the weekend.
He has just finished a load of custom parts for the new 358 Italia

[fordrallycar]

I was down there at the weekend.
He has just finished a load of custom parts for the new 358 Italia

Any pictures fella

[jacko996]

He will be able to make it to your requirements

Give Mike a call and see what he says


I was down there at the weekend.
He has just finished a load of custom parts for the new 358 Italia

Over £100 for a sheet I dont think so

Will use some plastic

[ronnie amis]

Have you tried carbon mods dave? Or eBay?

[jacko996]

Have you tried carbon mods dave? Or eBay?

not yet mate

[luca]

Out of interest Dave, what/where is for?

[jacko996]

Out of interest Dave, what/where is for?

Its for my boot floor Luke

Its got a huge hole in it now

[luca]

Well Carbon Mods as Ron said do it but there going to be around that price Mike quoted..

Lightness is not always cheap hey

[richyx]

3mm is quite thick, and 1 piece of carbon when vaced is around 0.5mm thick so needs quite a few sheets of carbon id imagine and could work out expensive

a bit of alloy orr plastic would do the same job

[escosgaz]

dave these any good seem to have diffrent materials/thicknesses maybe worth a shout
http://cgi.ebay.co.uk/Carbon-Fibre-E...item35a519f56c

[jacko996]

dave these any good seem to have diffrent materials/thicknesses maybe worth a shout
http://cgi.ebay.co.uk/Carbon-Fibre-E...item35a519f56c

Nice one, I will see if he does larger sizes

[jacko996]

The plastic is quite heavy so alloy sheet it will have to be

[twins]

Phil done us a nice sheet of carbon for our spare wheel well ,got him to back it up with some fiberglass matting to keep the costs down, and no lacquar finish just out the mould

[Mike Rainbird]

He has just finished a load of custom parts for the new 358 Italia

Is that like a 458 but smaller? ?