Announcement

Collapse
No announcement yet.

lazy car cleaners?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #31
    Originally posted by JHS View Post
    What do you bufty boys use then?
    Snow foam I expect Jan, I wanna get some!
    M3 CSL is here!

    Comment


    • #32
      Originally posted by JHS View Post
      What do you bufty boys use then?
      I do use water but I use a lambs wool wash mitt, dip the mitt in the bucket of water, wring it out then wipe each panel clean individualy. I never use a hose pipe on the car as no matter how long you leave it in your heated garage it will never dry out, trust me.

      My car has been in the garage since September 07, my garage is heated and theres very little humidity. The last time it got wet due to being out in the rain was on the way to National Day @ Rockingham 07.

      Last week I decided to replace the door seals (the ones around the top of the door & down the A pillar) When I removed the seal you wouldn't believe the amount of water that was trapped inside the seal, I was shocked. Needless to say I took all the other seals off just to check & although the door seals were the worst there was water inside every seal. If it had been left who know what corrsoion could occur.
      XYZ Fabrications
      Bespoke, custom and low batch quantity cnc profiling, engraving and fabriactions, 07917757695

      Comment


      • #33
        Originally posted by Dan View Post
        Snow foam I expect Jan, I wanna get some!
        I keep hearing about this snow foam stuff, is it any good Dan?
        XYZ Fabrications
        Bespoke, custom and low batch quantity cnc profiling, engraving and fabriactions, 07917757695

        Comment


        • #34
          Originally posted by Monster View Post
          I keep hearing about this snow foam stuff, is it any good Dan?
          I've not used it yet fella but Oilcosworth on here does and said it's fantastic! I must admit I have heard only good things about it!

          How do you wash the soap off your car then mate?
          M3 CSL is here!

          Comment


          • #35
            Like I said mate, I wring the wash mitt out & wipe each panel. Repaet until clean.

            Once its clean I do the same again with luke warm water (no soap) to get any residue off.

            By the time I've done the whole car the little amount of water on the panels has dried naturally.

            Then either a quick once over with Megs Quick Detailer or if I'm feeling like it a coat of Clearkote Carnuba Wax
            XYZ Fabrications
            Bespoke, custom and low batch quantity cnc profiling, engraving and fabriactions, 07917757695

            Comment


            • #36
              Originally posted by Monster View Post
              I do use water but I use a lambs wool wash mitt, dip the mitt in the bucket of water, wring it out then wipe each panel clean individualy. I never use a hose pipe on the car as no matter how long you leave it in your heated garage it will never dry out, trust me.

              My car has been in the garage since September 07, my garage is heated and theres very little humidity. The last time it got wet due to being out in the rain was on the way to National Day @ Rockingham 07.

              Last week I decided to replace the door seals (the ones around the top of the door & down the A pillar) When I removed the seal you wouldn't believe the amount of water that was trapped inside the seal, I was shocked. Needless to say I took all the other seals off just to check & although the door seals were the worst there was water inside every seal. If it had been left who know what corrsoion could occur.
              You are just crazy though If you're going to get that picky you cant ever take it out But that would be wrong too, rubber seals and gaskets would start leaking

              Comment


              • #37
                Oh believe me it does get use, 7 points on my licence will testify to that
                XYZ Fabrications
                Bespoke, custom and low batch quantity cnc profiling, engraving and fabriactions, 07917757695

                Comment


                • #38
                  mine gets used gets cleaned as well but not as good as you guys. When the summer comes I might go to town with it

                  Comment


                  • #39
                    Originally posted by Monster View Post
                    Like I said mate, I wring the wash mitt out & wipe each panel. Repaet until clean.

                    Once its clean I do the same again with luke warm water (no soap) to get any residue off.

                    By the time I've done the whole car the little amount of water on the panels has dried naturally.

                    Then either a quick once over with Megs Quick Detailer or if I'm feeling like it a coat of Clearkote Carnuba Wax
                    Ahh i'm with you now mate!

                    I think i'd still get soap and water everywhere even doing it that way! I take it then that you've got 2 wash mits? As I only have one! lol
                    M3 CSL is here!

                    Comment


                    • #40
                      Yes mate, 2 wash mitts. & a Poorboys drying towel
                      XYZ Fabrications
                      Bespoke, custom and low batch quantity cnc profiling, engraving and fabriactions, 07917757695

                      Comment


                      • #41
                        I need to get registered on that detailingworld site, think I'm gonna get the new Megs Machine before I go worrying about more swirl marks!
                        M3 CSL is here!

                        Comment


                        • #42
                          I got the g220. i love it,best investment by far for me but i do do other peoples cars too.
                          sigpic

                          guns for show,knives for a pro

                          Comment


                          • #43
                            I am still undecided on snow foam, when I first saw it I thought it looked great, but the longer I leave it I am not sure if its just the gimmicky side of it I like
                            Also I have heard stories of issues with foam lances not fitting correctly etc, if you let your car get filthy dirty it's probably great because the less you touch your car at this stage the better as you aren't rubbing grit and sh*t into your paintwork, mine never gets that bad though, even my Audi gets a regular wash so I will leave it and see if I come round to the idea.....
                            Mat

                            Black RS500 resto http://www.escortrscosworth.com/foru...ead.php?t=8547

                            Extended concours resto http://www.escortrscosworth.com/foru...hread.php?t=48

                            Comment


                            • #44
                              Nick
                              lol at the towel

                              I've been using snow foam for about a year now. It makes washing the car so much easier, gets rid of some dirt and softens the rest. I went through a phase where I thought its a gimmick, probably because I was using it on a cleanish car or being stingy on the amount I was using.

                              I really appreciate SF now, for the first time I gave the car a proper SF touchless wash only and I was really amazed how well it worked. The car was filthy & black and after shiny .

                              Like said, dilute a generous amount about an 1" in a 1l bottle and let the thing dwell with a bit of warm water .

                              Mat
                              you have to get the right lance that suits your p/washer

                              Comment


                              • #45
                                Originally posted by Monster View Post
                                Oh believe me it does get use, 7 points on my licence will testify to that
                                lol try having 102 points

                                i hate cleaning cars
                                sigpic

                                1/4 mile 9.52 @ 146mph so far

                                Comment

                                Working...
                                X