Spit Roast Anyone ?

[Darren]

Who's got a spit that they've used for on their

I'm after a favour please. What's the height from the floor to the pivot point on yours

I assume you all bolt to the back panel and into the front legs

[cossieben]

Hi mate, ill measure mine tonight for you, mine bolts thro back panel and into ends of chassis legs.

[Ashie]

Mine is 44 inches, but I had casters fitted which raised it further, its also adjustable for height in the "A" frame, I got it from a place in Bolton (MK2 Mania) I think it was called.

[Dave]

Mine is 44 inches, but I had casters fitted which raised it further, its also adjustable for height in the "A" frame, I got it from a place in Bolton (MK2 Mania) I think it was called.

Thanks for the heads up, think ill get a jig of those guys

Cheers

[cossieben]

Hi mate, ill measure mine tonight for you, mine bolts thro back panel and into ends of chassis legs.

Mine measures at 40 inches, I had to make mine at that as I've got low garage roof, when cars turning clears by an inch or so.

[richyx]

mk2 mainia as the one pictured, is there new design which you can put on yourself with no help and raise the car etc, very good design and well priced

[Darren]

Mine measures at 40 inches, I had to make mine at that as I've got low garage roof, when cars turning clears by an inch or so.

Cheers

Cheers everyone. I've measured mine and it was 44" but I've always felt it was too high.

So I've cut 6" out of the height but will be putting some 3" castors on so hopefully it should be a bit less nerve racking now getting it on and off the spit