AN between filter and coupling

[Escossie93]

I need the transition from the original fuel filter on my escos and to the fuel lines that is replaced with AN connections and steel braided fuel lines though I`ve replaced the org pump with an 023...
The one I got is not an AN and is way too long.
So can anybody link me the right one?

This is the one

[Escossie93]

Nobody know whats the right type? I just need to know what size...

[Escossie93]

Help please? the AN size is the same that follows the fittingkit for 023bosch...

[wes]

I don't think many understand the question you are asking (but your English is better than our Norwegian)

Looking at that pic i would guess that it is -6 sized, and this size is generally what is used when replacing the fuel lines to stainless braided lines.

[Escossie93]

Haha nice way to say it...
Ok, well my fuel line inner circle is around 8mm.so AN-6 then? The question is : what thread size is on the fuelfilter side? The threads are different and the case is that I need that red AN piece on the bottom picture. Note those pictures are only taken from an other page. I dont have the piece if u thought so... it was only to show what i needed, u see?

[grcossie]

Here you go mate

http://www.ebay.co.uk/itm/AN-6-SIERR...1#ht_572wt_813

Fittings of Norway should have this

[wes]

Haha nice way to say it...
Ok, well my fuel line inner circle is around 8mm.so AN-6 then? The question is : what thread size is on the fuelfilter side? The threads are different and the case is that I need that red AN piece on the bottom picture. Note those pictures are only taken from an other page. I dont have the piece if u thought so... it was only to show what i needed, u see?

I believe the fuel filter is M14 x 1.5 thread, so you'll need an m14x1.5 to -6 adapter

-6 aeroquip hose is around 8.6mm internal diameter so yes will be fine.

Edit **Just seen the link above, that's exactly the fitting you want!

[Escossie93]

Thanks GR, thought I had asked you about it