Due to my quaife box in my race car having an ATB centre diff I have to use their shorter output flange that fits the early 4x4 G/H reg saphs, this uses the older propshaft doughnut with the bearing attached, I have a few of these but what I don't have is the outpout flange they are different from an esc cos one as the centres between the bolts are 90mm not 85 like the esc cos,
they can be identified by the bulge in the casting between the bolts as shown below
early 4x4 that I need
late 4x4 that I have lots of lol
the doughnut i'm using is the one on the right
late 4x4 on the left early on the right
nice of ford to use different sized hole centres on the same doughnut
This could well hold up my race car build so has anyone got a broken early 4x4 box that I can salvage this part off please
cheers,
steve
they can be identified by the bulge in the casting between the bolts as shown below
early 4x4 that I need
late 4x4 that I have lots of lol
the doughnut i'm using is the one on the right
late 4x4 on the left early on the right
nice of ford to use different sized hole centres on the same doughnut
This could well hold up my race car build so has anyone got a broken early 4x4 box that I can salvage this part off please
cheers,
steve
Comment