Brake Bells - Powder Coat or Anodise?

[AGAR]

Hi guys,

the bells in my APs are getting a bit scabby and I'd like to give them a freshen up. I was thinking of either powdercoating them or getting them anodised - what one would give the best finish in terms of durability?

Cheers,

Rich

[Carlo]

I would anodise them mate prob better to let the heat out as well , peterbourough plating does it and a good turnaround time

[M K]

The inner wheel face sits against the bell face so powder coat is not a good idea as it will be thick and not flat,

Get them anodised but if you have a friend with a lathe take the tiniest amount off the outter face before anodising as it will give them a like new finish

[hughy]

Nice one as I will be looking to do same

[Gray_rs]

IF it was my car, I would get them done gold anodised

[AGAR]

IF it was my car, I would get them done gold anodised

That's the plan - gold anodised

I'll get them sent down to Peterborough plating once it's off the road for the winter.