If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
After fitting the diff and fitting kit my prop dose not fit at the center bearing holes are about 5mm out so what have people done to over come this thought this was a straight forward job
sigpic
Built by my self dp motorsport 700.6bhp 520ftlb efr9180 2.4bar m.a.d mapped flat out is the only way
After fitting the diff and fitting kit my prop dose not fit at the center bearing holes are about 5mm out so what have people done to over come this thought this was a straight forward job
After fitting the diff and fitting kit my prop dose not fit at the center bearing holes are about 5mm out so what have people done to over come this thought this was a straight forward job
i have only modified the prop adapter on 3 doors as the prop must be longer ,so i dont know why yours doesn't fit dave
Comment