Tweet
I want to remove my front bumper tomorrow, can anybody help me with what bolts I have to undo and any clips etc please?
-
-
2 twist clips bottom of the front wings and 2 bolts in each chassis leg, under the front end.
The inside bolt has to be taken out however the one nearest the front just has to be un loosened.
Dave.
-
Ok thanks hope it's that easy!!Comment
-
it is lol.Originally posted by dansmith215 View Post
the inner bolt on the passenger side is really hard to get at though.
Dave.Comment
-
So there is only two clips and two bolts to undo??Comment
-
2 clips 4 boltsOriginally posted by dansmith215 View Post
But only the 2 rear bolts that have to be removed, the front ones only need to be loosened as Dave wrote earlier.
Comment
-
see, easy lol.
you will have to take out the indicators, fog lights and the water feed pipe to the washer bottle too.
Dave.Comment
-
I have forgotten how to get the indicators and fog lamps out, do the indicators come out first?Comment
-
-
flick the plastic tab up, above the indicator and it will pop out,use a tiny screwdriver or similarComment
-
Passenger side bolt is a pain in the arse...couldn't get anything on it without removing all the stuff around it, and didn't want to disturb any of that so i gave up and did what I needed to do the hard way. lol.
Think I read somewhere to be careful if you take out the washer bottle tank because the brackets are prone to snapping or something like that. There was something I vaguely remember that put me off going to those lengths anyway.
Flat-head screwdriver in a thin rag to go in above the indicator to lift the tab and it'll pop out.
Good luck!Comment
-
I dont think any type of socket or cut down spanner can undo the outer passenger side bolt.
Unless you hit the bolt a few times with a hammer and chisel to get it to slide out.
Dave.Comment
Comment