Back in December B13 Jus got in touch with me and asked if i could make him a billet rear cover that would incorporate both rear pieces, at the time i only had 2.5d cad so was unable to design it the way he wanted. But with me upgrading to 3d and now having a better understanding of cad i thought i would give it a go.
Now his a Lovely Lad but hey he doesn't know how to use a ruler, the measurements he give me i took to be true as i didn't have a diff to measure, anyways i ordered material thinking all would be good to find out he was 5mm short on the length and 1.5" to high on the thickness
Said Material
So over the last week ive been keeping my head down working away on this, this is a prototype and still needs a lot doing, another day should see it finished. Im going over to Justins with it on Monday to try it in the car and then i will travel on down to Bara Motorsport as he will check it over to make sure all is well.
Hope you guys enjoy the pictures.
Now his a Lovely Lad but hey he doesn't know how to use a ruler, the measurements he give me i took to be true as i didn't have a diff to measure, anyways i ordered material thinking all would be good to find out he was 5mm short on the length and 1.5" to high on the thickness
Said Material
So over the last week ive been keeping my head down working away on this, this is a prototype and still needs a lot doing, another day should see it finished. Im going over to Justins with it on Monday to try it in the car and then i will travel on down to Bara Motorsport as he will check it over to make sure all is well.
Hope you guys enjoy the pictures.
Comment