Any ideas what's causing my car to over fuel so bad?

[mark shead]

If you have a afr gauge take it for a drive and see what's it fueling like as it may only be tick over where the problem is

Mark

[lee2cossies]

Looks like I may have to bite the bullet then and take it to a mapper.
Mark, I have afr guage but it's not mot'd I need to sort this issue out so I can mot it!
Only other issue thinking of it is the chip was used on an escort so maybe it was running a lamb sensor where as I havnt got mine connected yet?

[cossiedavid]

Lee could be map cencer tps set wrong or cam timing ports wont make as much of a differance

[lee2cossies]

Lee could be map cencer tps set wrong or cam timing ports wont make as much of a differance

Tried a good map sensor off a running car and another tps and set it up Dave. Cam timing is spot on checked a few times, I'm starting to think maybe the chip has a lamba sensor wrote in it and I havnt got one connected?

[DAI COSSY]

so many things can make differences though, cam timing being one,
if it was me, id want to do the job in 2 parts at that spec, get the car in and check diagnostics and set up, then map it a base to allow you to run in on, then bring it back once done for some boost.

what inlet manifold is it on?

Hi lee,have to agree with James prob best get someone set it up first as last why not get Adam to take it to your mapper to sort out or trailer it there bud?

[kjc300]

Does it rev over 4k or not?

Double check the blue water temp sensor near the dipstick is plugged in properly.

[James @ Auto Dynamix]

L8 doesn't have limp home

[lee2cossies]

Hi lee,have to agree with James prob best get someone set it up first as last why not get Adam to take it to your mapper to sort out or trailer it there bud?

That's what il end up doing Dai, going to send him a message when I get chance. Gutting part is iv rebuilt the whole car and built the whole engine and wanted to finish it all myself without taking it some where but giving up now! Least it will be done ready to go then everything else is ready to go.

[lee2cossies]

Does it rev over 4k or not?

Double check the blue water temp sensor near the dipstick is plugged in properly.

It revs ok, up to 5400rpm so far on the monitor, iv tried 2 new coolant temp sensors and the plug.

[DAI COSSY]

That's what il end up doing Dai, going to send him a message when I get chance. Gutting part is iv rebuilt the whole car and built the whole engine and wanted to finish it all myself without taking it some where but giving up now! Least it will be done ready to go then everything else is ready to go.

Lee I totally understand that mate, but it's far quicker and less stress to let the pros do these parts they see Peaple like me and you every day and we can cause more damage guessing is what I've learned
So get your money out you tight arse lol.....

[lee2cossies]

Lee I totally understand that mate, but it's far quicker and less stress to let the pros do these parts they see Peaple like me and you every day and we can cause more damage guessing is what I've learned
So get your money out you tight arse lol.....

Lol. I should have taken it somewhere a long time ago really save wasting time! Il have to dig deep to get my money out or what's left of it with the mrs!

[DAI COSSY]

Lol. I should have taken it somewhere a long time ago really save wasting time! Il have to dig deep to get my money out or what's left of it with the mrs!

Buying a house for you bud, took8 years to finish the 3dr when I baught mine then I stripped it again

[lee2cossies]

That's it mate! I think new intercooler and 6 degree beam she thinks new kitchen!