7064 manifold to close to alternator

[georgie1]

I think a lot if people are missing half the issue here, belts need to be long enough to allow the alternator to pivot away from exhaust manifold.
If belts are short ones you will still be close even with drop brackets.

make sense

[Ridgey]

[sydneyvon]

I think a lot if people are missing half the issue here, belts need to be long enough to allow the alternator to pivot away from exhaust manifold.
If belts are short ones you will still be close even with drop brackets.

I'm sure it won't be hard to find a longer belts

In theroy dropping the alternator down 40mm vertical the belt length won't change any way

[Ridgey]

Your dropping the pivot point, so the same belt length I think pivots the alt up so you don't get the full benefit.

[sydneyvon]

Got the bracket from anembro all fitted would like a bigger drop but this will do also going wrap the tube

Si

[Ridgey]

You almost have full adjustment available to move it further away and down for the cost of 2 belts which would be probably less than £10.
Every little bit helps, and it looks like you don't have the rear alt heat shield.