If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Good good, just as long as both versions differ greatly to ensure people don't get confused. How much are you selling them at then Mark?
Mine were done to experiment with 3d machining as its the first time ive done it, i wanted to run a few off to get a better understanding on what speed and feeds i could run with Aluminium . Mine are not for sale at the minute as im only completing 3 so Justin and Steve Punting can run them to see if there up to the job.
If there going to break these guys will break them.
Mine and Marks will be different, @ Mark why have you drew it in 2.5?
Hi Rich, if they wernt going on such power cars i would of sent you 1 mate.
Mine were done to experiment with 3d machining as its the first time ive done it, i wanted to run a few off to get a better understanding on what speed and feeds i could run with Aluminium . Mine are not for sale at the minute as im only completing 3 so Justin and Steve Punting can run them to see if there up to the job.
If there going to break these guys will break them.
Mine and Marks will be different, @ Mark why have you drew it in 2.5?
Hi Rich, if they wernt going on such power cars i would of sent you 1 mate.
hi mark
most of it on this side is a lot easier and faster to draw in featurecam then just import the bowl area from powershape into featurecam and overlay your drawing in there ,drawing it all in solid works or powershape makes your drawing /solid model look good but takes longer ,whats your cycle time on the first side /op
steven has jumped ship has he now hes seen yours lol I told you yours look good
hope this helps mate
mark
hi mark
most of it on this side is a lot easier and faster to draw in featurecam then just import the bowl area from powershape into featurecam and overlay your drawing in there ,drawing it all in solid works or powershape makes your drawing /solid model look good but takes longer ,whats your cycle time on the first side /op
steven has jumped ship has he now hes seen yours lol I told you yours look good
hope this helps mate
mark
So if you werent making any other than justins what are these all for an ornament then
I like them but i dont like them enough to call them an ornament, with being new to 3d High Speed Machining im still needing to gain experience with speed and feeds. With them already being machined i thought i might as well finish them, i wont sell any until Justin and Steve has done a few miles to see if i encounter any problems.
If all is well then i will sell them, if there no good i will machine them into little ornaments.
Im going to Justins tomorrow to fit his and hopefully we can get a good few miles done in the car, justin i hope you have gloves ready for me lol.
Comment